CLASS RACER FORUM - View Single Post

FED 387 · 03-26-2010, 09:42 AM

for the amount I need Splash Zone would be cost prohibitive!!!!! That stuff is about $80 per small container. Will look into trying maybe JB Weld or Devcon too---thanx for all the ideas tho I appreciate the input---By the way this is going into an ALUMINUM SHEET METAL INTAKE MANIFOLLD not a cast manifold---do not know if that makes any difference. But keep those ideas coming will look into all of them---thanx Comp387

03-26-2010, 09:42 AM	#6
FED 387 VIP Member Join Date: Jun 2006 Posts: 3,410 Likes: 508 Liked 329 Times in 177 Posts	Re: intake manifold epoxy for the amount I need Splash Zone would be cost prohibitive!!!!! That stuff is about $80 per small container. Will look into trying maybe JB Weld or Devcon too---thanx for all the ideas tho I appreciate the input---By the way this is going into an ALUMINUM SHEET METAL INTAKE MANIFOLLD not a cast manifold---do not know if that makes any difference. But keep those ideas coming will look into all of them---thanx Comp387