CLASS RACER FORUM - View Single Post

ss3011 · 10-06-2009, 05:36 PM

Lower fitting is "To Cooler"
Best place to put Temp Gauge is into the pan
The governor shift points are determined by a combination of the weights and the springs. The smaller weights basically control the WOT 1-2 and 2-3 shift points. Raise the 2-3 shift point first by lightening up the small weights, do this in small steps. Then use the springs to dial in the 1-2 shift. The lighter the springs the higher the shift point. B&M makes a kit , if you get in trouble.

10-06-2009, 05:36 PM	#2
ss3011 Senior Member Join Date: Feb 2002 Location: Southeast Michigan Posts: 909 Likes: 70 Liked 239 Times in 114 Posts	Re: TH400 Questions Lower fitting is "To Cooler" Best place to put Temp Gauge is into the pan The governor shift points are determined by a combination of the weights and the springs. The smaller weights basically control the WOT 1-2 and 2-3 shift points. Raise the 2-3 shift point first by lightening up the small weights, do this in small steps. Then use the springs to dial in the 1-2 shift. The lighter the springs the higher the shift point. B&M makes a kit , if you get in trouble.