CLASS RACER FORUM - View Single Post

Run to Rund · 07-01-2009, 09:22 AM

I got the CM kit from ART in Florida and it was completely up to my expectations, good price. The only fitment issue would be the main hoop and they will check their plans against your measurements to be sure it is right. My application was a bit unusual (66-442) and they custom bent me a hoop to fit, since their Chevelle pattern was a little different, same price. They notch the ends of the straight tubes, but I ground them because I was using odd angles to put the bars where i wanted them, so I can't comment on the quality of their notches. You want a very close fit for CM/TIG welding so plan to take time for careful fitting.

07-01-2009, 09:22 AM	#6
Run to Rund Senior Member Join Date: Sep 2007 Location: Henderson, NV Posts: 583 Likes: 8 Liked 54 Times in 27 Posts	Re: CM cage for stock eliminator. I got the CM kit from ART in Florida and it was completely up to my expectations, good price. The only fitment issue would be the main hoop and they will check their plans against your measurements to be sure it is right. My application was a bit unusual (66-442) and they custom bent me a hoop to fit, since their Chevelle pattern was a little different, same price. They notch the ends of the straight tubes, but I ground them because I was using odd angles to put the bars where i wanted them, so I can't comment on the quality of their notches. You want a very close fit for CM/TIG welding so plan to take time for careful fitting.