CLASS RACER FORUM - View Single Post

Chad E532 · 04-05-2009, 09:19 PM

Thanks for the tips.
I was able to get the spring out that did not locate properly up in the frame rail but it took a combination of a spring compressor, floor jack, chain, and pry bar to get it out of there.
Now that I have the new Moroso units in I have the "gasser" look and need to trim them down some. I have a separate post looking for the rule of thumb of what each 1/4 coil removed equates to in inches of drop.
Thanks,
Chad

04-05-2009, 09:19 PM	#5
Chad E532 Member Join Date: Jul 2008 Location: Lindstrom MN Posts: 156 Likes: 7 Liked 54 Times in 7 Posts	Re: Front Spring Install Help Thanks for the tips. I was able to get the spring out that did not locate properly up in the frame rail but it took a combination of a spring compressor, floor jack, chain, and pry bar to get it out of there. Now that I have the new Moroso units in I have the "gasser" look and need to trim them down some. I have a separate post looking for the rule of thumb of what each 1/4 coil removed equates to in inches of drop. Thanks, Chad