Z28 restoration ride height
 

Any of you 69 Camaro guru's know where I can find a ride height spec for a 69 Z28 302 ,4-spd , no air ..... I'm finishing off a customers fresh restoration and he thinks it looks too high in front. ...... I've been looking for a height spec ,but havn't found one. ....... The springs are brand new OEM NOS,and the car has been on the ground with the control arm bolts loose for about 2 months. ........ I seem to remember they were a little high in the front, back when they were new,but I get a little fuzzy after 38 days, let alone 38 years. .... Tom

Tom,

Tons of knowledgable guys on www.yenko.net that could answer your questions and more.

Todd

Thanks Mark, I forgot about Jerry. .. I'll see him at the Atco points race this week. I think the car sits correctly, but I want to make sure. ... Tom

Tom,
When it comes to 69' camaros i dont know of anyone more knowledgeable then my friend Jeff Miller.

Email me at Speedygoomba@yahoo.com and i'll give you his phone number.

he owns the nicest 69' camaro z28 with a crossram setup that i've ever seen.

Has it been rolled back and forth at all, or is it still in the same place as it was when it was let down off the jack?

~Pete
1970 Nova
12.653@105.43

Re: Z28 restoration ride height
 

I have a picture from 1976, I didn't change any of the suspension at this time. Send me an email and I will email the picture back to you
philip.miles@siemens.com

Re: Z28 restoration ride height
 

Thanks for the replys guys, I'd have responded sooner,but I'v been on the National event circus for the last 2 weeks! ...... I've checked the height against the service specs,and it's 2 1/2" higher than it should be. ..... Casey, you can e-mail me @gasracing@aol.com .... T om