Wanted suggestions how to create low drag Wilwood brakes
 

Guys,
I'm looking for suggestions on how to create low drag brakes. I have Wilwood 4 piston caliper brakes front & rear on my Gen 3 GT/DA 92 Camaro. Is there a kit one can buy? The TDM brakes are out of the question.
Thanks for looking,

Re: Wanted suggestions how to create low drag Wilwood brake
 

I shim the caliber with spacer to make sure they are centered
on the disc properly (usually they are not). They still have more
drag than the more expensive brands that my son runs on his cars!

Re: Wanted suggestions how to create low drag Wilwood brake
 

As well as making sure the caliper is center I have small stiff springs I put between the pads so the cotter pin holds the springs in place.

Re: Wanted suggestions how to create low drag Wilwood brake
 

you buy Mark Williams brakes.:D

Re: Wanted suggestions how to create low drag Wilwood brake
 

Or Lamb brakes ….There are always budget minded racers that will take the Wilwood’s off your hands ,,..Lamb brakes = $$ well spent ….:):)

Re: Wanted suggestions how to create low drag Wilwood brake
 

there's good reason why you won't find wilwood brakes installed on any car built for drag racing by a professional chassis shop

Re: Wanted suggestions how to create low drag Wilwood brake
 

Doesn’t Wilwood offer a low drag “ o” ring to replace the square cut seals in the calipers?

Re: Wanted suggestions how to create low drag Wilwood brake
 

Making sure the calipers are centered is a no brainer , but switching to drilled rotors was the best thing I did. No more drag. This and the right pads.
Mine are Wilwood.

Re: Wanted suggestions how to create low drag Wilwood brake
 

Mark,
I did look yesterday and I did'nt see any. I will call Monday.
Thanks for the reply,

Re: Wanted suggestions how to create low drag Wilwood brake
 

Ed,
What have you been up to? I have seen you post in a long time. Do you still have the Firebird?