Tom Waters shield for 200R4 ?
 

Has anyone used this shield in a Buick Regal and if so how was the fit? I have an 87 Grand National and don't want to dent or modify the body. Thanks in advance for any input.

https://racecarpartsdepot.com/shop?o...s%2Fgm-200-4-r

Re: Tom Waters shield for 200R4 ?
 

I sent the company an email and have had no response . Any input would be appreciated .

Re: Tom Waters shield for 200R4 ?
 

JW makes a Bell for the 200. Might be worth checking into it.

Re: Tom Waters shield for 200R4 ?
 

I made some inquiries about a shield for a 904 in an A body Barracuda and got quick responses, so you might try again.

They told me they needed three inches of clearance on each side and we did not have that., your mileage may vary.

Went with a CSR (which was hard to find) but had to beat the floorboard like a rented mule to get it in.

Good luck!

Re: Tom Waters shield for 200R4 ?
 

For what its worth I have the TWR shield in a 68-72 GM A-body on a metric 200. It touched the floor on the passengers side just a bit. All other places it is OK.

Re: Tom Waters shield for 200R4 ?
 

Thanks for the responses, I am going to email them again and then check for the 3 inches around the trans. I think a blanket will be the best for my car. There is no way I am beating the floors on an original paint car.

Re: Tom Waters shield for 200R4 ?
 

If you get a blanket you might check with Stroud Safety, they will make them custom if needed and they will recertify them. I don't know how common that is but I do now everyone does not do that.

Re: Tom Waters shield for 200R4 ?
 

Big thanks, most blankets are too big and hang down. I want a nice fit if I go this route.