Q-jet ID
 

Anyone recognize this builder?
https://i.imgur.com/xPrbRZq.jpg

Re: Q-jet ID
 

Scott Welborn from SC worked on quite a few Q jets years ago...

Re: Q-jet ID
 

Your car being from D-1 I would say Joe Scott

Re: Q-jet ID
 

Could be Joe Scott from northern Pa

Re: Q-jet ID
 

Thanks guys.

Re: Q-jet ID
 

Look on the bottom of the throttle plate - If a Joe Scott piece, will be vibra penciled with Scott on the bottom and also the rear (with a number). Last one I worked on was #72 (that was probably at least 30+ yrs old) and also had a brazed secondary lever so all four throttle blades opened at the same time.
Regards,
Dissident

Re: Q-jet ID
 

Thanks I'll check when it comes off. Don't think it's been apart in a while, seems ok WOT but loads up at idle a bit. I'll go through it or send it to someone.

Re: Q-jet ID
 

Also as an addendum, no the fuel system is probably not ideal (blue pump and holley regulator, deadhead) but the pressure is turned down to 5 to eliminate that as the rich condition.