Edelbrock head accepted for Sbc in S/S ?
 

Was looking to see if any changes on my combo and seen where there are 3 or 4 edelbrock heads listed as replacements for sbc s/s.When did this happen ? .......Victor

Re: Edelbrock head accepted for Sbc in S/S ?
 

What year and engine? On my page for the 68 Ford, the accepted Canfield and AFR heads are listed by number at the bottom and Edelbrock by name only. Across the top the Edelbrock head numbers are entered in small type like they were an afterthought or correction.

Are they highlighted in yellow? They do that with changes.

Dale

Re: Edelbrock head accepted for Sbc in S/S ?
 

Victor, it happened yesterday. J.R.

Re: Edelbrock head accepted for Sbc in S/S ?
 

Good for everyone. Sponsors can get involved. Racers can get new easier to find parts. Only problem is an image thing for the "way it was" starting with all original parts. Spectators can identify the brands and support the makers of the parts..

Re: Edelbrock head accepted for Sbc in S/S ?
 

All i had heard about was the Dart Iron Eagle head being approved,but I'm usually the last to know anyhow......thanks Victor

Re: Edelbrock head accepted for Sbc in S/S ?
 

I see that listing now. Lots of good stuff to stick on a SBC.

Dale

Re: Edelbrock head accepted for Sbc in S/S ?
 

I did a search on all these numbers and found nothing other than 608879 part number. But that number isn't listed with the last digit of 9. When are they (Edelbrock) going to make them?

Ernie Neal
SS 354

Re: Edelbrock head accepted for Sbc in S/S ?
 

Called and found out 283 not approved to use aftermarket heads. The only head I could find(like Ernie stated) is a 1.94 valve 185cc head. That wont work anyway for a 283 without a ton of work. I was told the other 3 not available yet.

Re: Edelbrock head accepted for Sbc in S/S ?
 

Based on the code used on the stock car classification guide, only engines with "$" (might be a sub section symbol) under the CID can run the newly listed heads. Seems to start with 327s.

Dale