Electric fuel pressure guage
 

Has anyone had experience (good or bad) using an electric fuel pressure
guage?

Re: Electric fuel pressure guage
 

I love digital fuel gauges. Easy to read, and no spastic needles floppin' around. And no expensive isolators, anti-freeze, and hoses. And in my experience they've proven to be very accurate.

Re: Electric fuel pressure guage
 

Ken, did you mount your sending unit on the block, fender, firewall or elsewhere.
Terry K

Re: Electric fuel pressure guage
 

The sender was screwed into the regulator (1/8th inchNPT) and I retained a small 15# gauge tee'd into the regulator for comparison purposes. Pretty much like an electric temp sender would look like; sender wired straight to the gauge. Easy to read LED numbers in 1/2 pound increments, even at speed. Not all that expensive either.

I wish I had kept that gauge; with car attached of course!

Re: Electric fuel pressure guage
 

Autometer electric gauge, sender at the elbow for the carb. Works fine.

Re: Electric fuel pressure guage
 

Looking at the Auto Meter 4361 installation guide, it recommends that the sending unit
be isolated from vibration.That's why I was wondering about the best place for the sending unit.

Re: Electric fuel pressure guage
 

I tried the autometer electric digital water temp and oil pressure guages. They were nice and worked good at idle, but when I put RPM's up on the motor, then the display would go crazy flickering, couldn't read. Don't know if a grounding issue or what, I did not have time to trouble shoot so I took back off and put my mechanical ones back on.

Re: Electric fuel pressure guage
 

http://www.autometer.com/cat_gaugede...id=2824&sid=15
This the one I use.

Re: Electric fuel pressure guage
 

Thanks Bob, your guage is basically the same as the one(4361) I'm looking at.
Did you mount your sending unit on the block?
Terry K

Re: Electric fuel pressure guage
 

I actually put the sending unit in the 1/8 pipe hole on the regulator. It works fine.