CLASS RACER FORUM

CLASS RACER FORUM (https://classracer.com/classforum/index.php)
-   Stock and Super Stock Tech (https://classracer.com/classforum/forumdisplay.php?f=4)
-   -   Turbo 400 shifting issue (https://classracer.com/classforum/showthread.php?t=36292)

novassdude 09-26-2011 01:50 PM

Turbo 400 shifting issue
 
Finally got to got the car out to try. Still waiting on a converter for my 200 trans so we used my old bracket turbo 400. It s set up to just put it in drive and shift at 6000rpm.
First pass the car burped a little on the line (pretty sure to cold and to low an idle) any way from there on car ran clean shifted at 6000 just as I thoght it should. Shut it off at the 1000 went to the pits looked it all over and every thing looked good. Went up to make the next pass and it would not shift. Vacume line was still in place any good ideas where to look?

Jim Kaekel 09-26-2011 04:54 PM

Re: Turbo 400 shifting issue
 
First, check the governor, valve may be stuck or gear is stripped, gear is nylon. Check modulator valve and be sure it isn't stuck.

ss3011 09-27-2011 07:39 PM

Re: Turbo 400 shifting issue
 
Did it work in the burnout box, but then wouldn't shift on the pass ?

novassdude 09-27-2011 07:56 PM

Re: Turbo 400 shifting issue
 
Quote:

Originally Posted by ss3011 (Post 284938)
Did it work in the burnout box, but then wouldn't shift on the pass ?

Yes it did shift in the box. I did go to neutral after the box to clear it out.

ss3011 09-27-2011 10:21 PM

Re: Turbo 400 shifting issue
 
It still drives in 1st, but does not shift ? Does it back up ?

Mike Leopold 09-27-2011 10:31 PM

Re: Turbo 400 shifting issue
 
I have lost 2nd gear on a turbo 400 a few times over the years. The problem is usually a broken sprag on the direct drum. If the sprag won't hold torque and slips you won't have 2nd gear. if it locks up and won't freewheel, you will smoke the direct clutch when shifting to 3rd gear. One time a piece of gasket material broke off and blocked the hole in the bolt in the center support that feeds the intermediate clutch. This also resulted in no 2nd gear.

Jim Kaekel 09-28-2011 08:20 AM

Re: Turbo 400 shifting issue
 
Mike is correct, that is also a possibility. Just be sure to check the simple stuff (governor, modulator) first before you pull the unit out.

novassdude 09-28-2011 01:45 PM

Re: Turbo 400 shifting issue
 
Quote:

Originally Posted by ss3011 (Post 284971)
It still drives in 1st, but does not shift ? Does it back up ?

Yes I drove it back to the pits no problem it backed up fine when we went to load it. It did shift to second on the return road when I wasn't under hard exceleration.

It just stumped me cause the first pass the tranny acted perfectly.

I am staring to think checkers is looking like a good sport.

I will probably just park it again put in the good tranny next spring.

Thanks for all the help


All times are GMT -4. The time now is 01:04 PM.

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.
Copyright Class Racer.com. All Rights Reserved. Designated trademarks and brands are the property of their respective owners.