strange axles in ford mustang housing
 

i am running strange pro race axles in a 1968 ford mustang housing. do i need to run the factory axle seals or will the o rings on the strange axles be enough? strange is not open today and i would like to put it together. thanks ron

Re: strange axles in ford mustang housing
 

"O" rings will be enough to seal the housing at both ends.Put a little grease or oil on them so you don't cut the seals as the axles are installed.

Re: strange axles in ford mustang housing
 

make sure the ID of the housing is nice and clean. bearing going in and out have a tendency to gaul up a bit. a small dia. flap wheel on an air grinder will polish up the bore. when nice and clean, the axle will slide out with a good hard pull by hand. use white lube or anti-seeze in the bore.
rod in Az