CLASS RACER FORUM

CLASS RACER FORUM (https://classracer.com/classforum/index.php)
-   Stock and Super Stock Tech (https://classracer.com/classforum/forumdisplay.php?f=4)
-   -   Pinion Angle (https://classracer.com/classforum/showthread.php?t=24856)

Dan Bernay 04-02-2010 07:02 AM
Pinion Angle
 
With car on level surface where is best place to put protractor to check/adjust pinion angle?
Thanks,Dan.

Floyd Gomez 04-02-2010 12:19 PM
Re: Pinion Angle
 
I always drop the shaft but that is my preference

Tom Goldman 04-02-2010 03:33 PM
Re: Pinion Angle
 
Quote:
Originally Posted by montys 55 (Post 179422)
dan if its a rear cover style remove the cover and use the cover surfice.
if its a ham type use the mounting surface if the housing is empty or you can remove the driveshaft an use the flat on the front of the pinion
Only trust the yoke if it's a machined billet piece from Strange or Mark Williams . .....The forged or cast type are sometimes ground ,not machined at the U- bolt surface. ...........this method works well otherwise. ..Tom

Dan Bernay 04-03-2010 05:19 AM
Re: Pinion Angle
 
Thanks for the help guys!


All times are GMT -4. The time now is 04:43 PM.

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.
Copyright Class Racer.com. All Rights Reserved. Designated trademarks and brands are the property of their respective owners.