intake manifold epoxy
 

Looking for a source for the epoxy that is used to fill in the voids grinding areas around the ports and such on aluminum intake manifolds.The stuff I have seen has been either beige/gray or lite green...Anyone know of a brand name or a supplier--thanx comp 387

Re: intake manifold epoxy
 

Goodson Tool porting epoxy

Re: intake manifold epoxy
 

Use either Belzona #1111. It is great when using oxygenated fuels.

http://www.belzona.com/prod1k.aspx

or

POR Patch

http://www.por15.com/PORPATCH/productinfo/PPW/

Re: intake manifold epoxy
 

Thanx for the info will check into it this weekend--Comp 387

Re: intake manifold epoxy
 

I used Splah Zone in the past. I do not know if they have changed their formulation, however, when used with oxygenated fuels and other chemicals, it tends to break down.

Re: intake manifold epoxy
 

for the amount I need Splash Zone would be cost prohibitive!!!!! That stuff is about $80 per small container. Will look into trying maybe JB Weld or Devcon too---thanx for all the ideas tho I appreciate the input---By the way this is going into an ALUMINUM SHEET METAL INTAKE MANIFOLLD not a cast manifold---do not know if that makes any difference. But keep those ideas coming will look into all of them---thanx Comp387

Re: intake manifold epoxy
 

Al:
If your looking for an epoxy go to Smooth-On.com and check out their MT-13. By far the best epoxy I've found. You're right about JB Weld, it doesn't play well with gas. Danny