need Mopar W-8 head info
 

Anybody know what size fitting goes on a Mopar W-8 cylinder head on the water crossover passages???? Kinda looks like a 3/4-16 NF thread with a tapered seat---Is this correct??? Thanx comp 387

Re: need Mopar W-8 head info
 

If its the same as a W-9 I think its considered a female -8. The fittings I got for my
W-9 heads were "Earl's 985068 Blue Anodized Aluminum -6 AN Male to 3/4" -16 O-ring Port Adapter"

However my heads are out to have pistons fitted and I have not actually tried them in the heads.

Good Luck,
Bill Lamb

Re: need Mopar W-8 head info
 

Thanx for the reply---kinda thought that's what it was but after playing with about 30 different fittings just trying to get a "good" fit on one they all start looking the same----Thanx again will try one to make sure it fits---Got the whole engine together never occured to me to think about a fitting til it's all assembled---Thanx comp 387