Line Lock Plumbing?
Hi. I plumbed a Line Lock like this (below). It seemed like a clean way to plumb it without using a "T" inline. This saved a couple of potential places to leak :). But now someone mentioned to me that with the way I plumbed it, there won't be sufficient pressure to hold the car while doing a burnout. So should I plug one of the outlets on the Roll Control and "T" out of one port only?
Thoughts? Wayne http://i.imgur.com/b1YpHmMh.jpg |
Re: Line Lock Plumbing?
Pressure is pressure, doesn't matter if you had a T or used the LL body as the T, Once you activate the solenoid you pump the pedal and the LL is a one way check valve.
|
Re: Line Lock Plumbing?
Quote:
Wayne |
Re: Line Lock Plumbing?
You may want to add a small rubber pad to insulate the line lock from the fender well. This way you eliminate or lessen any vibrations or stress on the lines.
|
Re: Line Lock Plumbing?
Mine is plumbed the same way. Working fine. Looks great!
|
All times are GMT -4. The time now is 11:22 PM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright © Class Racer.com. All Rights Reserved. Designated trademarks and brands are the property of their respective owners.