driveshaft speed sensor
 

Can someone let me know the pin out configuration for the autometer drive shaft speed sensor? I want to use it with my mega squirt ecm. What color is ground, power and signal? I cold not find it on their website. Thanks.

Re: driveshaft speed sensor
 

Black is ground white is signal red is power that's the way we always run it Fed

Re: driveshaft speed sensor
 

Thanks Fed!! Im going to reuse my cable also that went to my tach. The end of the jumper cable at the sensor has a three wire connector but the other end that goes by the tach has a 4 wire connector. Is the fourth pin a shield?

Re: driveshaft speed sensor
 

Fed 387 or anyone else tell me what the placement in the connector for the power ground and signal is? looking left to right with clip up just like the picture.. Thanks for the help. Im making up a new cable from the sensor to my ecu.

https://s13.postimg.org/y48zs4f2f/5212_17.jpg

Re: driveshaft speed sensor
 

Ok, have the info I need. Ill post it here in case someone else will need it one day.

Connector has terminals marked A,B,C

A -Blue is ground
B- black is signal
C- tan is 12 volts