super stock 305 intakes
sorry, don't know now to cancel. . jeff
|
Re: super stock 305 intakes
touchy subject...
|
Re: super stock 305 intakes
Sir 305,
You might find that a GM OEM valve that is 2.00" diameter and has a hollow stem would work well when reduced in diameter and reshaped. The shape is best decided on a flow bench, but at least that is a good start. Since any valve job is legit, you might also find that something less than the original 45 degree face/seat is also more beneficial because of the relatively low lifts of those engines. However, like many things there are various opinions that can be either refuted or supported via your own test data.;) Regards, HB2:) Dissident Above comments are for Stock, not SS. However the selection of the valve might be the same answer and the face/seat be steeper than 45 degrees. Intake valve shape should end up with a 10-12max degree backside. |
Re: super stock 305 intake
I deleted the ? It was about intake manifolds. A lot of viewers of ? I understand now why I couldn't get the simplest answer. I respect that. tks jeff
|
All times are GMT -4. The time now is 03:25 AM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright © Class Racer.com. All Rights Reserved. Designated trademarks and brands are the property of their respective owners.