EZ Plate Systems
 

Any Super Class racers use an EZ Plate System? Curious - would like to hear some input if you use it.

Re: EZ Plate Systems
 

Cannot imagine you are going to find many since it is a MPH game and the EZ plate system does just the opposite by killing MPH. Good system though I have a lot of freinds that use them in the Gas classes with great success.

Re: EZ Plate Systems
 

I have used the E-Z Plate System for 2 years and love it.

Re: EZ Plate Systems
 

Which class and type of car?
Dan

Re: EZ Plate Systems
 

11.00 index, Super Street, and Hot Rod small block Vega.

Re: EZ Plate Systems
 

What about the Willys Carb restrictor plate? That is adjustable without adding or removing plates.

Re: EZ Plate Systems
 

I used a Willy's a few times when I was running some index races and it worked really well for me. Only problem I ever had was the threaded part started loosening and the vibration would cause it to open, someone told me about putting a little locktite on the threads and never had another issue. I did use it at a couple division races in hot rod and it was very dialable, my car was a slower car so the loss of mph was not an issue to me because I was used to looking over my shoulder 98% of the time anyway.

Re: EZ Plate Systems
 

I think if you are simply trying to shave a little in ET then these systems are likely the best way to go.

Re: EZ Plate Systems
 

Agree with this 100%, my car was a low hp car and would only be on the throttle stop around a half second and sometimes could be very unpredictable at times. I would say for racers only needing to slow down 3 or 4 tenths this would be the way to go otherwise go for the mph.

Re: EZ Plate Systems
 

Been using Willy's adjustable restrictor plate for the past 6 seasons. That said, there is no simplier, easier or quicker way to adjust your ET up to 5+ tenths in less than 30 seconds.

Re: EZ Plate Systems
 

Thanks for the input. I think the Willy's deal is the way to go for my car.

Re: EZ Plate Systems
 

Good choice. As has been stated, just put a drop of loctite( I use red) on the adjustment threads then turn all the way in and back out before using/setting the first time.

Re: EZ Plate Systems
 

I use the Willys for 7.0 racing and had the same issues with it moving by it self, use Locktite on it and very stable. I am happy with it but have several friends that use E-Z Plate and I like it also and the owner is VERY HELPFUL when you call to discuss. Later J.Smith 4621 racing 7.0

Re: EZ Plate Systems
 

I really wanted to use the Willys unit but they dont build one for a dominator carb.

Re: EZ Plate Systems
 

if you need it for a dominator here's where you go

http://www.etgenie.com/

and save your money, no need for the dial indicator.